OEM Customized Auto Parking Sensor - Supply Toy Lan 4500 FZJ80 FZJ100 original chip electric fuel injection pump assy OEM 23221-46060 – Haoyang

                       Welcome to contact me if you have any inquiry or question!

 

Supply Toy Lan Cruis 4500 FZJ80 FZJ100 original chip electric fuel injection pump assy OEM 23220-0P010

Hot Item Sales

  Electric Fuel Pump Description
 1, EFI pump should be installed by trained staff to implement and comply with the safety rules to prevent accidents. In strict accordance with car manufacturers dimension
Repair manuals, hope attention during the operation of environmental protection.
 2, removal and fuel pump should be installed by the first power supply (preferably temporarily remove the batteries are connected one), confirm circuit, oil, Fasteners, Accessories restitution after
You can power up commissioning.
 3, to prevent short-circuiting wires, pay attention to the pump positive and negative connected correctly.
 4. Where the replacement of pumps, tanks and piping should be thoroughly cleaned; the fuel pump 90% of failures are due to long-term accumulation of dirt tank caused by the inhalation of dirt will be reduced
The life of a small pump, causing pressure drop flow, the operator shall recommend the owner to clean the tank and associated piping, accessories.
 5. Make sure to keep clean and work at the pump, all the preparation work behind at work can make a clean hand out the new pumps, new pumps and older models and the entire outer
Type after verification to be replaced, absolutely prevent foreign matter from entering the hydraulic system.
 6. Do not use dirty, damaged filter installed new pumps, pump performance degradation should first check the filter and fuel filter, fuel pressure regulator and and
When replacing.
 7, falling off the fuel pump may not be used, or there will be a magnet broken or dangerous magnets debris will affect pump performance degradation or potential hazards (jam motor
Parts or the oil pipe valve).
 8, non-electric fuel pump is running at without oil.
 9, when the oil supply system fails, you should first check the battery voltage and fuses, and pump circuits, relays and the oil is faulty.
    10, when the general experience of checking the pump into a container filled with 2-5 liters of kerosene wide fingers should feel there is one (and similar to the tap) pressure. There strip
Pieces available 0-1.0MPA gauge, 20-200L / float flowmeter H typical parameters: pressure 0.3MPA flow 80L / H (except low-pressure pump.
    11, after the replacement of the pump, pay attention to check the tightness of the oil supply system piping.

More models in stock…

Packaging & Shipping