Auto parts 3RZ/RZJ120 Fuel pump for Japanese cars OEM 23221-75020

  Auto parts 3RZ/RZJ120 Fuel pump for Japanese cars OEM 23221-75020

Electric Fuel Pump Description
 1, EFI pump should be installed by trained staff to implement and comply with the safety rules to prevent accidents. In strict accordance with car manufacturers dimension
Repair manuals, hope attention during the operation of environmental protection.
 2, removal and fuel pump should be installed by the first power supply (preferably temporarily remove the batteries are connected one), confirm circuit, oil, Fasteners, Accessories restitution after
You can power up commissioning.
 3, to prevent short-circuiting wires, pay attention to the pump positive and negative connected correctly.
 4. Where the replacement of pumps, tanks and piping should be thoroughly cleaned; the fuel pump 90% of failures are due to long-term accumulation of dirt tank caused by the inhalation of dirt will be reduced
The life of a small pump, causing pressure drop flow, the operator shall recommend the owner to clean the tank and associated piping, accessories.
 5. Make sure to keep clean and work at the pump, all the preparation work behind at work can make a clean hand out the new pumps, new pumps and older models and the entire outer
Type after verification to be replaced, absolutely prevent foreign matter from entering the hydraulic system.
 6. Do not use dirty, damaged filter installed new pumps, pump performance degradation should first check the filter and fuel filter, fuel pressure regulator and and
When replacing.
 7, falling off the fuel pump may not be used, or there will be a magnet broken or dangerous magnets debris will affect pump performance degradation or potential hazards (jam motor
Parts or the oil pipe valve).
 8, non-electric fuel pump is running at without oil.
 9, when the oil supply system fails, you should first check the battery voltage and fuses, and pump circuits, relays and the oil is faulty.
    10, when the general experience of checking the pump into a container filled with 2-5 liters of kerosene wide fingers should feel there is one (and similar to the tap) pressure. There strip
Pieces available 0-1.0MPA gauge, 20-200L / float flowmeter H typical parameters: pressure 0.3MPA flow 80L / H (except low-pressure pump.
    11, after the replacement of the pump, pay attention to check the tightness of the oil supply system piping.

and more size in the store…. 

1.What can I do if could not find the goods on you website?

A:You’er much welcome to contact our sales with specific information (such as OE number, and the pictures of back side, front side and pin configuration etc),so that we can check it for you whether we can make the item or not.

2.How to get a quotation ?

A: Advice us the needed OE number, color, picture, etc via email or on-line chat tool. We will send you the quotation ASAP.

3.How do I know that you have sent out the parts?

A:Once the parts have been sent out, the tracking number will be provided so that you can check where your goods at all times.

4.What is your sample policy?

A:We can supply the sample, but customers have to pay the sample cost and the shipping cost.